Service & Panel Upgrades
Swap a rusted-out meter or undersized panel for a clean, modern, 200A service that's ready for solar, EVs, and electrification.
From first walkthrough to final inspection.
Every project is run by a licensed master electrician — no rotating subs.
- 01
Load Assessment
We inventory existing circuits, measured loads, and planned additions (EV, heat pump, solar, induction range). Service size is calculated to NEC 220 — not guessed.
- 02
Scope & Quote
Fixed-price scope: panel make/model, breaker layout, grounding/bonding updates, mast or meter-main work, and any utility coordination required.
- 03
Utility Coordination
We schedule the Rocky Mountain Power disconnect and reconnect, file the permit, and stage the work to minimize your power-down window (typically 4–6 hours).
- 04
Swap Day
Old panel demoed, new meter-main or panel set plumb, all circuits re-landed on labeled breakers, grounding electrode system brought up to current code.
- 05
Inspection & Energization
City inspector signs off, utility re-energizes, we test every circuit, label the directory, and walk you through the new layout.
Industry-leading equipment, installed correctly.
- Square D QO, Eaton CH, or Siemens panels (your preference)
- 200A or 400A service capacity
- Modern meter-main combo with main breaker outside
- Replacement of outdated or recalled sub-panels and breakers (Federal Pacific, Zinsco, Challenger, etc.)
- Whole-home surge protection (Type 2 SPD)
- Updated grounding electrode system (ground rods + UFER where applicable)
- Labeled circuit directory and as-built sketch
Ready for a real estimate? Let's walk your site.
Most projects start with a 30-minute on-site assessment. No high-pressure pitch — just an honest scope.